if you wanted the easiest jump in power, a chip and a ball and spring boost controller setup would most definitely satisfy that little need, without making the car overly noticable to cops via loud exhaust. intake isn't really going to do much except make the turbo louder at this point since we are excluding exhaust. and yea i do hafta agree with changing out the clutch. you also might look into getting a set of NICE sticky tires to keep the new torque under wraps(no pun intended) :roll:
__________________
1993 mr2 turbo, just a little moddified.........
1994 Gen II engine, 1996 close ratio tranny, CT20b turbo, ARC Intake, 1996 gen 3 ecu, HKS Super Sequential Blowoff Valve, HKS 43mm Boost Gauge, Greddy Dual PE Exhaust,Greddy Turbo Timer, Greddy Profec B boost controller(12 psi normal, 17 psi high~fuel cut is 18~) , Greddy Intercooler, Manjit IC Fan Shroud, Spal 7.5" Puller Fan, Ceramic Coated Turbo Heat Shield and Intercooler Piping, Bilstein Struts, Eibach Sportline Springs, Suspension Technique Sway Bars, GAB Strut Tower Bar, KAAZ LSD, Supra TT Fuel Pump and 540cc gen 3 injectors, 16" GAB Sport wheels, Yokohama AVS ES100 205/45/16 & 225/45/16, Powerslot rotors and EBC red stuff pads in front, and stock rear.
~phew~
|